Sanitary Stainless Steel Tri Clamp Weldless Bulkhead

We make sanitary stainless steel bulkhead for home brewing.

The 1-1/2" Triclover (TC) weldless bulkhead flange allows you to add a TC port to any tank or kettle with absolutely no welding or soldering. Just drill a hole and tighten the locknut.

Specs:

• SS 304 stainless steel

• made by CNC machine

• 35mm ID, 50.5mm (1.5")clamp flange, 35mm overall length, custom length is available

• food grade silicon O-ring

• 41mm or 1-5/8" threaded end diameter.

   

   

Installation Notes:

• Hole Size Required - 1-5/8" or 41mm. Note that the most pleasant tool to use for this is a knockout punch set. Since they are extremely cost prohibitive, the next best option is our tungsten carbide hose saw (40mm). After deburring the 40mm hole, the result is a clean 41mm hole. See the accessories column on the right for the bit.

• The oring contact is on the flange side of the fitting so make sure there are no burrs on that side of the hole.

• The lock nut hex measures 50.5mm. Turning it with an adjustable wrench does NOT work well. You'll need a socket or a box wrench. Since these tools are very rare, we offer a socket as an accessory. It requires a 1/2" drive ratchet.

• The front of the flange does not have flats for a wrench. The easiest way to hold the front of the flange for tightening is to clamp any other TC part on with the gasket and clamp (a blank cap works great). Once tight, you can insert a long rod or screw driver into the hole of the wingnut.